[ New messages · Members · Forum rules · Search · RSS ]
  • Page 1 of 1
  • 1
Forum moderator: DarkSoul  
Forum » Game cheats, hacks, other Hacking methods » Last Chaos hacks » Last Chaos hack list
Last Chaos hack list
DarkSoulDate: Sunday, 2008-05-04, 6:01 AM | Message # 1
Game master
Group: Administrators
Messages: 145
Reputation: 1
Status: Offline
These hacks work only with CE (Cheat Engine). You can download CE ---> HERE <---

All credits goes to LCsucks and to ppl who helped to find adress codes. smile

Open cheat engine first and then load Last Chaos in windowed mode. Click on the top left button of Cheat Engine and select the process "NKSP.EXE"

Attack Speed:
The following will allow you to make your attack around 4x faster than normal.

In the game, make a new character, a titan.

Now in cheat engine set "Scan Type" to Exact Value, and "Value Type" to 4 bytes. Then, with your weapon equipped, type in 14 in the "Value" box (make sure hex isn't checked) and click "First Scan".

After it is done scanning, unequip your weapon in the game, then type in 20 in the "Value" box and click "Next Scan".

You should be left with only 2-3 addresses in the Found box at this point. If you need to narrow it down some more, repeat the process doing "next scan" a couple times, and soon you should only have 1 left.

Double click that value to add it to the bottom box where you can edit the value. Now once you have the value you can go and make the desired class and use it on any of them.

When you want to speed it up, check the "Frozen" box next to the value, then double click on the number in the "Value" column. Lower it to any speed that you like, 1 being the fastest that it will go. Keep in mind that if you are far away from the servers the attack packets will stack because of lag and this will DC you, but if you have a good connection with little to no lag from the servers you can attack anywhere from 4x-6x faster (that is 4 through 6 hits in the time of 1 normal hit). If you start getting DCs from it, just set the value a little higher (anything from 1-8 will be faster than any character can attack normally).

Quick Way for the Rest of the Hacks:
Note: If this doesn't seem to work for you, follow the instructions below to obtain each cheat seperately.

In cheat engine, highlight the attack speed value, right click, and select copy. Now, right click on an empty portion below the attack value and click-paste (just click the paste button on the pop-up that comes up). Repeat this 5 times and you should have 6 "Attack Range" addresses.

Now, we will need to change the last 3 characters in the addresses for each new hack, so select any of them and double click on the address to change them. The addresses are as follows:

U.S. Version:
Attack Speed (xxxx68C8,4 Bytes): Base value is anywhere from 9-20, fastest speed is 1
Skill Speed (xxxx6920,4 Bytes): Base value is 0-1, change to 2 for quick skills.
Running Speed (xxxx68C0,Float): Base value is 6-7.5, 15 on mount. Suggest 12.5 on foot and 25 on mount for quick travelling.
Attack Range (xxxx68C4,Float): For Healers/Rogues using crossbows ONLY; Base value is around 15-20. Can go up to 30 without too many problems.
PvP Health Bar (xxxx65F5,4 Bytes): Values vary. Click on a monster and freeze it, and you should be able to see other player's life bar (cannot make a party while in this mode).
Monster Level (xxxx6620, 4 Bytes): Just tells you the targeted monster's level.
Targeted Player/Monster Max HP (xxxx6618, Float): Tells you the maximum HP from the targeted monster or player.
Targeted Player/Monster Current HP (xxxx661C, Float): Tells you the current HP from the targeted monster or player.

Malaysian Version:
Attack Speed (xxxx68D8,4 Bytes): Base value is anywhere from 9-20, fastest speed is 1
Skill Speed (xxxx6930,4 Bytes): Base value is 0-1, change to 2 for quick skills.
Running Speed (xxxx68D0,Float): Base value is 6-7.5, 15 on mount. Suggest 12.5 on foot and 25 on mount for quick travelling.
Attack Range (xxxx68D4,Float): For Healers/Rogues using crossbows ONLY; Base value is around 15-20. Can go up to 30 without too many problems.
PvP Health Bar (xxxx65F5,4 Bytes): Values vary. Click on a monster and freeze it, and you should be able to see other player's life bar (cannot make a party while in this mode).
Monster Level (xxxx6620, 4 Bytes): Just tells you the targeted monster's level.
Targeted Player/Monster Max HP (xxxx6618, Float): Tells you the maximum HP from the targeted monster or player.
Targeted Player/Monster Current HP (xxxx661C, Float): Tells you the current HP from the targeted monster or player.

If the above addresses do not do anything for you, then follow these instructions for the rest of the hacks:

Running Speed:
Since you will be killing so fast, it's a good idea to bump up your running speed so that it doesn't take you as long to run from monster to monster.
To do this, all you need to do is make a new Knight character and have a couple of haste potions.

In cheat engine, set the "Scan Type" to Exact Value and the "Value Type" to Float. Once you are in game, type 6 in the "Value" box (again, make sure Hex isn't checked) and click "First Scan".

After the search is over, use a Haste potion and while it is running type in 7 in the "Value" box and click "Next Scan".

After the haste wears off, type 6 in the "value" box and hit "Next Scan" again.

Now change the "Scan Type" to Unchanged Value and click "Next Scan" again. You should be left with only 1-2 addresses in the found box. It's not the green one so double click on the black one and it should add it to the bottom box for editing.

Once it is there, click the "Frozen" checkbox and double click the value of the address in the Value column. Now, characters normally run at a value of 6-8.5 and mounts alrways run at a value of 15. You will get stuttering if you set it too fast so for traditional running I suggest a value of 12.5 at the most, and on a mount a value of 25 at the most. Either way and you will be running like the wind Wink

Monster Levels:
This one isn't as cool as the other 2, but useful never the less. With any character go outside the north gate of juno and target a Fox. Set "Scan Type" to Exact Value and "Value Type" to 4 Bytes. Then, with the Fox still targeted but not being attacked (right click on them to do this) type 1 in the "Value" box and click "First Scan".

After it is done, find a Wolf (the smaller ones) and target it like you did the Fox. Then, type 2 in the "Value" box and click "Next Scan".

After it is finished, find an Elder Wolf, target it, type 3 in the "Value" box and click "Next Scan". After it is done you should only have one value left in the found box, so double click it and add it to the bottom box.

Now, this isn't one that you change, it just tells you what level monster you are fighting, which may make it easier than looking for a guide that has all the levels listed. Unfortunatly, it doesn't work with other players.

Attack Range (for ranged players like Mages, Healers, and Rogues using crossbows):
This hack can increase your attack range to 2x the normal distance. To do this, make a new rogue and enter the game and collect enough gold to buy a crossbow but hold on to your daggers.

First, set "Scan Type" to Exact Value and "Value Type" to Float. Then in game, equip your daggers on your rogue, type 2 in the "Value" box and click "First Scan".

After it has finished scanning, go back to the game and equip your crossbow. Go back to cheat engine and type 15 in the "Value" box and click "Next Scan".

Once finished, re-equip your daggers, type 2 in the "value" box and click "Next Scan" again. You should be left with 2-3 values in the Found box, and if you watch them there is probably only one that says the same. Double click it to add it to the bottom box for editing. If you still have too many results, repeat the process a couple times to narrow the results down some more.

As always, first click the "Frozen" checkbox and double click the value in the "Value" column. Now, with the crossbow equipped (remember this only works for ranged players), change the value to 30. Now you can attack monsters from far, far away. After you have the value you can switch to whatever character you would like to use it on. Remember, little things can block your fire so if you attack without doing damage, move a little closer and try again.

WARNING: Using either the Attack Speed hack or the Attack Range hack is VERY noticable on ranged players, so be careful if you are going to use it.

Skill Speed: Note: May change attack animations
This will make skills be cast instantly, and allow you to attack after casting much, much faster. To find this address, use your rogue again that we made for Attack Range.

First, with your crossbow equipped, search for the value of 1 (Exact Value, 4 Bytes).

After it is finished, equip your daggers and search for the value of 0 (Exact Value, 4 Bytes). Repeat this process until you find the address and add it to the bottom box by double-clicking it.

Now, freeze it and change the value to 2. Tada! Instant Skills!

Player Health Bar: For advanced users only, if you can't figure out how to use it then don't whine about it
This value likes to change around alot but the best way to get it is to go outside the north gates of Randol with any character. Target a fox (right click) and search for the value "16777216" (Exact Value, 4 Bytes).

Once that is finished, go back to town and right click on any NPC or other player. While they are targeted, go back to CE and search for any changed values (ala, Scan Type = Changed Value).

Repeat this process until you narrow down your list of suspects. There might be a few of them so just freeze and target other players to see which one works. While working, you can see the health of pretty much ANYTHING in the game that you can target (including player's pets hehe).

However, the player health one is glitchy (it's not that big of a deal but can be annoying when your PvPing and thier health disappears) and you can NOT form a party when the value is frozen at 16777216. If you want to make a party, turn it off and retarget the player.


 
Forum » Game cheats, hacks, other Hacking methods » Last Chaos hacks » Last Chaos hack list
  • Page 1 of 1
  • 1
Search:

Login form
Search
Our poll
Do you care about war in Gruzia ?
Total of answers: 16
Site friends
  • Create your own site
  • Statistics